The HT.P Positional Coupler is suitable for connecting 2 bars of the same diameter where neither bar can be rotated and at least 1 bar can be moved.

The HT.P Positional Coupler satisfies the requirements of CARES Appendix TA1-B for couplers with reinforcing bars and is produced under an ISO9001 quality management system certified by CARES.

The couplers are delivered to site welded to the appropriate rebars. The formation of the joint is achieved by screwing the male and female sections of the coupler together.The joint should be tightened using a wrench until no further movement is possible between the two sections.

Installation

The two sections of the joint and female coupler are brought together.

Both sections are then screwed together by rotating the female coupler using a wrench.

Finished joint is tightened with a wrench until there is no further movement between sections.

Dimensions

Coupler Ref	Rebar Dia (mm)	Dimensions (mm)
Coupler Ref	Rebar Dia (mm)	A	B1	B2	C	D	E	L
HT.P.16	14	18	14	17	41	33	25	70 ± 2
HT.P.16	16	18	14	17	41	33	25	70 ± 2
HT.P.20	20	22	19	22	45	39	28	75 ± 2
HT.P.25	25	28	25	28	55	51	36	95 ± 3
HT.P.32	28	36	30	33	65	60	46	115 ± 3
HT.P.32	32	36	30	33	65	60	46	115 ± 3
HT.P.40	40	42	37	40	75	73	55	130 ± 4
HT.P.50	50	50	49	53	93	98	70	150 ± 4

HT Couplers Enquiries

For more information on HT Couplers, please contact our HT Solutions Manager, Grant Dean.

12 The Green, Richmond, Surrey, TW9 1PX

Tel: +44 (0)20 8940 7578
Fax: +44 (0)20 8332 1757
Email: g.dean@hy-ten.co.uk